Visit HBM - Experience measurement technology

Within the scope of university lectures, we offer on-site visits to our Darmstadt headquarters at regular intervals. Technical papers are presented and theoretical knowledge can be applied in practice by working with the multitude of models available in the HBM Academy Application and Training Center (ATC).

In addition, the DKD calibration laboratory (German Calibration Service) can be visited. In 1977, HBM was the first DKD calibration laboratory accredited for the measurand force. Subsequent accreditation covered the measured quantities: voltage ratio (mV/V), torque and pressure. New calibration machines for new measuring ranges and higher accuracy have been developed over the past years.

This is what our visitors say ...

• "Our visit to HBM was great. Especially the guided tour of the calibration laboratory and the torque department was very interesting."

  Prof. Dr.-Ing. Roland Werthschützky
  Leiter Fachgebiet Mess- und Sensortechnik am Institut für Elektromechanische Konstruktionen, TU Darmstadt (Head of the Department of Measurement and Sensor Technology at Electromechanical Design Institute of Darmstadt Technical University)

• "We really enjoyed our visit. Thank you very much for your commitment and the guided tour."

  Dipl.-Ing. Christian Hatzfeld
  Wiss. Assistent, verantwortlich für die Vorlesung "Elektrische Messtechnik" am Institut für Elektromechanische Konstruktionen, TU Darmstadt (Assistant professor responsible for the "Elektrische Messtechnik" (Electrical measurement technology) lecture at Electromechanical Design Institute of Darmstadt Technical University)